SCPI Commands Appendix B
Model N6705 User’s Guide 193
SCPI Command Description
Triggers the external data logger immediately
:SOURce <source>, (@chanlist)
Sets the external data logger trigger source
<source> = BUS, EXTernal, IMMediate, PIN<n>
Triggers the current histogram immediately (N6781A, N6782A)
:SOURce <source>, (@chanlist)
Sets the current histogram trigger source (N6781A, N6782A)
<source> = BUS, EXTernal, IMMediate, PIN<n>
Triggers the output immediately
:SOURce <source>, (@chanlist)
Sets the output trigger source <source> = BUS, EXTernal,
IMMediate, PIN<n>, TRANsient<n>
Common Commands
Standard event status enable
Saves an instrument state
Return event status register
Set service request enable register
Return instrument identification
Enable "operation complete" bit in ESR
Performs self-test, then returns result
Recalls a saved instrument state
Pauses additional command processing
Return output channel descriptions
until all device commands are done
Interface Settings
Factory-shipped non-volatile LAN settings
Dynamic DNS naming service
Obtain DNS server from DHCP
Ethernet Auto-negotiation
Other factory-shipped non-volatile settings
Admin/Calibration password
Digital port function (all pins)
Voltage and Current knobs
Digital port polarity (all pins)
To Next Page
Loading...
