18 Quick Start Guide
N9310A RF Signal Generator
SCPI Command List
SCPI Command Utility
Frequency
SCPI command
:FREQuency:CW <val> <unit>
:FREQuency:CW?
Set CW frequency
:FREQuency:RF:STARt <val> <unit>
:FREQuency:RF:STARt?
Set RF start frequency
:FREQuency:LF:STARt <val> <unit>
:FREQuency:LF:STARt?
Set LF start frequency
:FREQuency:RF:STOP <val> <unit>
:FREQuency:RF:STOP?
Set RF stop frequency
:FREQuency:LF:STOP <val> <unit>
:FREQuency:LF:STOP?
Set LF stop frequency
:FREQuency:RF:SCALe LOG|LIN
:FREQuency:RF:SCALe?
Set Sweep Scaling
Amplitude
SCPI command
:AMPLitude:CW <val> <unit>
:AMPLitude:CW?
Set CW frequency
:AMPLitude:STARt <val> <unit>
:AMPLitude:STARt?
Set Start Amplitude
:AMPLitude:STOP <val> <unit>
:AMPLitude:STOP?
Set Stop Amplitude
Trigger
SCPI command
:TRIGger:IMMediate Sweep immediately
:TRIGger:SSWP Trigger a single sweep
Sweep
SCPI command
:SWEep:RF:STATe ON|OFF|1|0
:SWEep:RF:STATe?
Turn On/Off RF Sweep
:SWEep:LF:STATe ON|OFF|1|0
:SWEep:LF:STATe?
Turn On/Off LF Sweep
:SWEep:AMPLitude:STATe ON|OFF|1|0
:SWEep:AMPLitude:STATe?
Turn On/Off Ampl Sweep
To Next Page
Loading...
