N9310A RF Signal generator
Quick Start Guide 19
:SWEep:RF:STARt <val> <unit>
:SWEep:RF:STARt?
Set RF start frequency
:SWEep:LF:STARt <val> <unit>
:SWEep:LF:STARt?
Set LF start frequency
:SWEep:RF:STOP <val> <unit>
:SWEep:RF:STOP?
Set RF stop frequency
:SWEep:LF:STOP <val> <unit>
:SWEep:LF:STOP?
Set LF stop frequency
:SWEep:AMPLitude:STARt <val> <unit>
:SWEep:AMPLitude:STARt?
Set start amplitude
:SWEep:AMPLitude:STOP <val> <unit>
:SWEep:AMPLitude:STOP?
Set stop amplitude
:SWEep:STEP:POINts <val>
:SWEep:STEP:POINts?
Set sweep point
:SWEep:STEP:DWELl <val> <unit>
:SWEep:STEP:DWELl?
Set step dwell time
:SWEep:REPeat SINGle|CONTinuous
:SWEep:REPeat?
Set sweep repeat
:SWEep:STRG IMMediate|EXT|KEY
:SWEep:STRG?
Set sweep trigger
:SWEep:STRG:SLOPe EXTN|EXTP
:SWEep:STRG:SLOPe?
Set sweep trigger slope
:SWEep:PTRG IMMediate|EXT|KEY
:SWEep:PTRG?
Set point trigger
:SWEep:PTRG:SLOPe EXTN|EXTP
:SWEep:PTRG:SLOPe?
Set point trigger slope
:SWEep:DIRection UP|DOWN
:SWEep:DIRection?
Set sweep directon
AM
SCPI command
:AM:STATe ON|OFF|1|0
:AM:STATe?
Turn on/off AM
SCPI Command Utility
To Next Page
Loading...
