SISTEMI DI SICUREZZA 5 SAFETY SYSTEMS
FL - FP - FA 5-7
Dispositivo antiurto per rientro automatico
(Fig. 5-5):
La trinciatrice è e
uipa
iata con una valvola
montata
sul martinetto del parallelo
ramma
al fine di permet-
terne il rientro automatico
uando incontra una forte
resistenza da parte del prodotto da trinciare.
Regolazione:
Personale richiesto: 1 OPERATORE
In caso di necessità, per ese
uire la re
olazione della
valvola procedere nel modo se
uente:
• Arrestare la trinciatrice disinserendo la presa di
forza della trattrice ed attendere che il rotore sia
completamente fermo.
QUANDO SI DISINSERISCE LA PRESA DI FORZA
DELLA TRATTRICE, L’ALBERO CARDANICO
SMETTE DI RUOTARE MA CI
NON SIGNIFICA
CHE IL ROTORE SIA COMPLETAMENTE FERMO,
POICH
ALL’INTERNO DELLA SCATOLA INGRA-
NAGGI DELLA TRINCIATRICE
PRESENTE IL
DISPOSITIVO DI RUOTA LIBERA.
•Svitare
nel caso in cui la trinciatrice non dovesse
rientrare
o avvitare
nel caso in cui la trinciatrice
dovesse rientrare troppo facilmente
la vite
1
di un
uarto di
iro per volta.
PERICOLO !
Shock-proof device for automatic re-entering
(Fig. 5-5):
The shredder is provided with a valve
mounted on the
ack of the parallelo
ram
in order to allow the auto-
matic re-enterin
when the product that has to be
shredded creates a stron
resistance.
Adjustment:
Re
uired staff: 1 OPERATOR
If necessar
, follow the under-mentioned indications in
order to ad
ust the valve:
• Stop the shredder disconnectin
the PTO of the
tractor and wait until the rotor is perfectl
motion-
less.
WHEN YOU DISCONNECT THE PTO OF THE
TRACTOR, THE CARDAN SHAFT STOPS ROTAT-
ING, BUT THIS DOES NOT MEAN THAT THE
ROTOR IS PERFECTLY MOTIONLESS, SINCE INTO
THE GEARBOX OF THE TRACTOR THERE IS THE
FREE WHEEL DEVICE.
•Unscrew
if the shredder does not re-enter
or screw
if the shredder re-enters too easil
the screw 1 of a
uarter of a turn at a time.