Doc No. FM5626 issue A Page 4
2. IMPORTANT SAFETY INSTRUCTIONS
Read and understand these instructions before use. Keep these instructions for future reference.
Take care when working on step ladders during installation or service.
Do not disassemble this product when connected to a power source.
No user serviceable parts inside. Refer all servicing to qualified service personnel.
Only use the manufacturer’s Power Supply (Model No. GT-41062-1812) supplied with the Modem.
This product should be located at least 2 metres away from other electronic equipment. Failure to
provide this separation may result in reduced radio range.
Do not locate this product above a radiator or other heat source.
Do not expose to direct sunlight.
Do not submerge in water and do not use in damp or humid conditions.
Do not expose this product to dripping or splashing water.
Liquids can cause a failure and/or a fire hazard.
Clean with a hard-surface disinfectant wipe or a damp cloth and a non-abrasive cleaning product.
Polish with a dry duster. DO NOT use a wet cloth.
Avoid using harsh, abrasive or corrosive cleaning agents or detergents (e.g. scouring powders, bleaches,
polishes, etc.) when cleaning this product.
At the end of its life this product should be disposed of and recycled in accordance with the
environmental regulations. See the Regulatory Information in section 3 below.
To Next Page
Loading...
