Why does my AIMS Battery Charger turn off when charging from a generator?
If your AIMS Battery Charger turns off while charging from a generator, it could be due to high AC input voltages from the generator. Try loading the generator down with a heavy load or turn down the generator's output voltage.
Why is my AIMS Battery Charger supplying a lower charge rate?
If the AIMS Battery Charger is supplying a lower charge rate, the charger controls might be improperly set, the AC input voltage might be low, or the battery/AC input connections could be loose. Refer to the section on adjusting the “Charger Rate”, ensure you are using a qualified AC power source, and check all DC/AC connections.
How to fix an AIMS Inverter that will not turn on?
If the AIMS Inverter will not turn on during initial power up, it may be due to disconnected batteries, loose battery-side connections, or low battery voltage. Check the batteries and cable connections, inspect the DC fuse and breaker, and charge the battery.
What to do if sensitive loads turn off during transfer between grid and inverting with AIMS Battery Charger?
If sensitive loads turn off temporarily when transferring between grid and inverting on your AIMS Battery Charger, the inverter's low voltage trip voltage may be too low to sustain certain loads. Select a narrow AC voltage in the DIP switch, or install a UPS if possible.
Details general safety precautions for operating the inverter, including environmental considerations and ventilation requirements.
Highlights crucial safety measures to follow when handling and working with batteries to prevent accidents and injuries.
Provides an overview of the Global LF Series inverter/charger, its features, and efficiency.
Lists various applications and equipment suitable for use with the inverter/charger.
Illustrates the physical layout and connection points of the inverter, showing terminals and ports.
Summarizes the key distinguishing characteristics and capabilities of the Global LF Series inverter.
Details inverter performance specifications including Invert, AC Charger, Transfer, frequency, power saving, and protections.
Provides guidelines for selecting an appropriate and safe installation site for the inverter.
Details the recommended wire gauge and connection procedures for the DC power input.
Explains the correct methods for connecting AC input and output wires, including wiring options.
Specifies the requirements for proper grounding of the inverter for safety and protection.
Provides dimensional drawings for mounting frames for different inverter models.
Presents detailed technical specifications for various models of the inverter and charger.
Details bypass and protection parameters, voltage limits, and frequency settings.
Lists physical dimensions, weights, and mounting information for different inverter models.
General| Series | LF Series |
|---|---|
| Protection Features | Over Voltage, Over Temperature, Short Circuit, Reverse Polarity |
| Compatibility | Lead Acid, AGM, Gel, Lithium |
| Operating Temperature | -20°C to 50°C |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Output Current | 10A / 20A / 30A / 40A |
| Charging Stages | 3-stage (Bulk, Absorption, Float) |
To Next Page