Setting Up Your Aipas eBike Setting Up Your Aipas eBike
14 15
For better pedaling, safety and overall riding comfort, positioning the seat at the right height is
important. The rider's leg length is used to determine the seat's position. When you pedal, your
hips should remain level and your legs should be almost fully extended at the bottom of the
pedal stroke, but not over-extended.
To determine the right seat height, sit on the eBike with one pedal at its lowest point and place
the ball of your foot on the pedal. Your leg should be almost fully extended(not locked out) with
a slight bend at the knee.
1
Open the quick-release lever by swing-
ing the lever open and outward fully.
2
Move the seat up and down by sliding
the seatpost in or out of the seat tube.
DO NOT raise the seatpost beyond the
minimum insertion marking etched into
the seatpost tube.
3
Adujst the seat and the head of the seat
is parallel with the top tube.
4
Close the quick-release lever using your
palm or finger.
1
Loosen the four screws in
the seat stay.
2
Align the rear rack with
the seat stay and tighten
the screws.
3
Take off the nuts on the
taillight.
6
For ride safe, secure the
taillight cable to the
seatstay with nylon cable
ties.
4
Assembly the taillight into
the rear rack.Screwing the
nuts.
5
Use wrench to tighten the
nuts.
To Next Page
Loading...