- 16 -
4-2
Programming (GH-NS)
a. Programming with a PC
• You can use a PC to enter data and write in or change resident
names.
• Use the connection cable that comes with GH-NS to connect
your PC to GH-NS.
• In your PC, install the setup tool program from the CD that
comes with the GH-BC.
For information on how to use the setup tool, see the text (.txt)
file that is installed in the same folder as the setup tool (.exe).
b. Programming with GH-NS and GH-10K
• Confirm that "Welcome" is shown on the Display, indicating
that the system is in standby mode.
You can change the "Welcome" text.
• First, set the system to program mode. (For details, see above.)
Before you begin programming, we recommend that you
register a new exclusive ID code for yourself so that the
system is not accessed by others. (For details, see 4-3)
If you have forgotten your ID code, set the switch (#1) to ON
for approximately 2 seconds. The ID code will be reset to the
default setting of " 1111".
b
a
GH-NS
PC
1
ON
1
2 3 4
ON
Enter Program Mode
WELCOME
INITIAL ID CODE
INITIAL ID CODE
DISPLAY
Select Menu & Quit
YOUR OPERATION
RE-ENTER ID CODE
YOUR OPERATION
SELECT LANGUAGE
DISPLAY
MENU
Standby
FORWARD
Scroll
BACKWARD
Go to Menu 1-8
1
2
3
4
5
6
7
8
9
SELECT LANGUAGE
CHANGE ID CODE
ACCESS CODE
RESIDENT INFO
SET TIMER
CHANGE GREETING
TRANSFER DATA
SCROLL SPEED
QUIT
1 1 1 1
ID CODE = + 4 digit
1 1 1 1
DECIDE & BACK
DECIDE & NEXT
To Next Page
Loading...
Need help?
General
