16
■
Designate residential station(s) that receive a
call from this station [ROOM STATION CALL
SETTINGS]
You can set whether or not the other residential stations receive
a call (all call or single call) from this station. The setting can
be made for each station. A station set to “DISABLE” will not
receive a call from this station.
From HOME window, touch
1
SETTINGS
→
CALL
→
ROOM STATION CALL SETTINGS
.
The PIN entry window is displayed.
Enter the 4-digit PIN by using the touchscreen, and
2
then touch
ENTER
.
“ID 1” to “ID 8” (other than this station) are displayed.
"ID1" shows the master station.
•
"ID2" shows the sub master station whose ID switch is
•
set to “2”. (The same applies to "ID3" to "ID8".)
The ID number of this station is not displayed.
*
If a wrong PIN has been entered, an error message
*
is displayed. Enter correct PIN. (See page 15 for PIN
settings).
To change the setting for “ID2”, select “ENABLE” or
3
“DISABLE”.
ENABLE .....Allows the station to receive a call from this
station.
DISABLE ....Does not allow the station to receive a call
from this station.
Repeat for other stations.
4
Use
*
" "
or
" "
to scroll between ID numbers.
When the setting has fi nished, touch
5
ENTER
.
Setting the microphone on/off for a
call from a residential station [TALK] -
[PRIVACY MODE]
This setting enables or disables the PRIVACY MODE.
When receiving a call from a residential station individually;
When set to "ENABLE", privacy mode is set. In this state, a
•
caller cannot hear audio from this station.
When set to "DISABLE", audio can be heard from this station
•
allowing for 2-way communication.
From HOME window, touch
1
SETTINGS
→
TALK
.
Touch
2
PRIVACY MODE
and select “ENABLE” or
“DISABLE”.
When the setting has fi nished, touch
3
ENTER
.
Setting for indoor monitoring
[MONITOR] - [ROOM MONITOR]
When set to “ENABLE”, this station can be monitored by the
other residential stations. When set to “DISABLE”, this station
cannot be monitored by other stations.
From HOME window, touch
1
SETTINGS
→
MONITOR
.
Touch
2
ROOM MONITOR
and select “ENABLE” or
“DISABLE”.
When the setting has fi nished, touch
3
ENTER
.
To Next Page
Loading...
