Air Science Purair BASIC - Packaging Contents

Air Science
®
120 6th Street \ Fort Myers, FL 33907 \ T 239-489-0024 \ Toll Free 800-306-0656 \ F 800-306-0677 \ www.airscience.com
6 \ USER OPERATION MANUAL: Purair Basic Series
4. Removing the Packaging Material.
» The cabinet is protected by Styrofoam, cardboard and/or shrink-wrap.
» IfyoundanydamageduringthisstageofunpackingpleaserefertotheDamaged Freight Claim
Information on our website.
» We recommend leaving the cabinet secured with straps to the pallet until the cabinet is located in its
approximatenalpositiontofacilitateeaseandsafetyinhandling.
Note: Choosing the best location for your cabinet in order to achieve optimum operating performance
is determined by a number of factors. Please refer to the next chapter for some guidelines.
5. Moving the Cabinet.
» Whenliftingthepalletwiththecabinet,alwaysensurethattheoorjackormechanicallifttruckhasfully
entered under the pallet. This is to increase the stability of the cabinet and reduce the risk of the cabinet
falling down. Please use a suitable extension bar when necessary. During the moving of the cabinet,
ensure there is enough distance between the supports of the pallet and the ground. Dragging the pallet
against the ground will damage the pallet and possibly your new cabinet.
» When removing cabinet from pallet or placing cabinet onto pallet, use at least two people.
6. Removing the Strapping.
» Remove the strapping by cutting it at a safe position to prevent any scratching the surface of your new
cabinet.
» Do not discard the packaging material for your cabinet until you have checked all of the components,
installed and tested the unit.
7. Lifting the Cabinet.
» The cabinet can be lifted in two sections: The HEAD unit and ENCLOSURE.
» Install the cabinet on the existing work surface or Air Science support stand (if ordered).
Note:
» When installing the cabinet onto an existing work surface, ensure that the structure can safely support
thecombinedweightofthecabinetandanyrelatedequipment.Somemodicationstotheworksurface
may be necessary.
» The work surface should be smooth, non-porous and resistant to the disinfectants and chemicals used
in conjunction with the cabinet.
2.2 Packaging Contents
The following items are included with your manual:
• Test Report
In case this manual and/or test report is lost or misplaced, Air Science retains a copy in our les. A replace-
ment copy can be obtained by contacting Air Science and providing the cabinet model, serial number and a
brief description of the information desired.