Air Science Purair BASIC - Installation and Setup Steps

Air Science
®
120 6th Street \ Fort Myers, FL 33907 \ T 239-489-0024 \ Toll Free 800-306-0656 \ F 800-306-0677 \ www.airscience.com
8 \ USER OPERATION MANUAL: Purair Basic Series
Power Cord:
» 1)Forunitsintendedtobeoperatedat120volts(NorthAmerica):UseaUL-listedandCSA-certiedcord
set consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in
length and a parallel blade, grounding-type attachment plug rated 15 amperes, 125 volts.
» 2) For units intended to be operated at 230 volts: Use a cord set with a grounding-type attachment plug.
The cord set should have the appropriate safety approvals for the country in which the equipment will be
installed.
» 3)Connectonlytopoweroutletwithreliableprotectionearthconnection.Useonlycertieddetachable
mains power cord set with adequate rating to operate the equipment.
3.3 Installing Your Cabinet
1. Please refer to Unpacking Your Cabinet - page 5.
2. Inspectyourcabinetcarefully.ShouldyoundanydefectpleaserefertotheourLegacy Warranty.
3. Peel off any protective masking that was left on the cabinet during manufacturing.
4. Wipe down the interior and exterior of the cabinet with water or a mild household detergent.
5. Connect cabinet to the main power supply and turn on the blower. Each cabinet requires its own dedicated
13A (230V) or 15A (115V) power outlet which should not be shared with other appliances.
WARNING! Do not move the cabinet without observing the following precautions:
• Observe the necessary precautions when relocating the cabinet, as it is heavy.
• Warning - Tipping Hazard. Pushing high up on the unit may cause system to tip over. Be careful when
moving. Move with assistance only.