Setting-up 7
Connecting an Optional Pitot Probe or Airflow (straight
pitot) Probe
When connected to a pitot probe, air velocity or air volume can be
-
pressure ports on the Model TA465-P using two pieces of tubing
of equal length. The total pressure port of the pitot probe
-
For information on how to perform a duct traverse, refer to
Application Note AF-106.
The pitot velocity needs a valid temperature to perform the
standard or actual velocity correction. This is accomplished
able of
measuring temperature (plug in probe or thermocouple) is
connected, the
The duct air temperature must then be manually inputted by
be or Thermocouple 1 or 2, and no
probe is connected, dashes (------) will appear on the
display.
For more information on entering the temperature manually,
refer to the Actual/Standard Setup section of this manual.
To Next Page
Loading...