Pre-filters* Cleaning the filters whenever the filter indicator is on**
Max2 filters* Replacing the filters whenever the filter indicator is on***
* After cleaning or replacing the filters, make sure to reset the filter indicator on the control panel. (P. 25 P. 24)
** 400S/300S: Approximately 2 weeks (based on daily 8 hours usage at max speed)
Filter cleaning cycle can be adjustable in the smart phone application .
400/300: Approximately 2 weeks (based on daily 8 hours usage at max speed)
*** Approximately 12 months (based on daily 8 hours usage at max speed)
The filter lifetime may differ depending on the real running time of product and the fan speed. The figures above are
evaluated on a general basis.
Front, left, and right cover
Every 2 months (recommended)Air outlet
Pollution sensor
CAUTION
• Be sure to turn off the power and disconnect the power plug before cleaning each part or replacing the Max2 filters.
• Do not use detergents that contain solvents, thinners, bleach, chlorine, or abrasives.
• Do not immerse the product in water or spray the product with water.
• If you use water to clean the pre-filter, dry the pre-filter in the shade before re-installing it.
When the exterior is dirty, use a slightly damp
cloth.
NOTE
• If you are using the product in a polluted environment, clean each part or replace the Max2 filters more frequently
than the recommended cycle.
• Using a Airmega genuine filter is recommended for optimum performance.
• The Max2 filters are not reusable. Do not try to clean them with water. Always replace them with a new one.
• When disposing of the old Max2 filters, follow your local regulations.
To Next Page
Loading...
