AirSep AS-E - Page 139

AS-D+—AS-P Series Instruction Manual 139
AirSep Corporation
6. SERVICE / SPARE PARTS
We recommend that valves be directed to our service cen-
ters for maintenance. The service centers are equipped to
provide rapid turn-around at a reasonable cost and oer
new valve warranty with all reconditioned valves.
NOTE: When sending goods to the service center for
repair, do not disassemble them. Clean the valve carefully
and ush the valve internals. Include the material safety
datasheet(s) (MSDS) for all media owing through the
valve. Valves sent to the service center without MSDS
datasheet(s) will not be accepted.
For further information on spare parts and service or
assistance visit our web-site at www.metso.com/valves.
NOTE: When ordering spare parts, always include the
following information:
a) Valve catalog code from identication plate,
b) If the valve is serialized – the serial number (from
identication plate).
c) From Figure 4, the ballooned part number, part
name and quantity required.
Figure 4
16
8
21
16
17
19
1
2
6
5
3
53
4
NON FIRETESTED
22
24
13
6
5
2
52
Bolts or
Tie Rods
54
(Socket Weld or
Butt Weld Only)
PARTS LIST
ITEM PART NAME QTY
1 Body 1
2 End Cap 2
3 Ball 1
4 Stem 1
5 Seat 2
6 Body Seal 2
7 Secondary Stem Seal 1
8 Stem Seal 2
16 Stem Nut 2
17 Handle 2
19 Shakeproof Washer 1
21 Compression Ring 2
22 Identication Ring 1
24* Stem Bearing 1
52 Body Bolt / Tie Rod 4
53 Body Nut 4/8
54 Weld End Tag 1
* For Non Fire-Tested valves, items (24) and
(7) are replaced by a single stem bearing
(24). (See Figure 3)
IMO 3/18
6 IMO-202 EN