Why is there only a limited air supply from my Airwell GC 24 DCI?
A limited air supply from your Airwell Heat Pump, especially if accompanied by a whistling noise and ice formation on the indoor unit coil in cooling mode, suggests a lack of refrigerant. You should charge the unit after localizing the leak.
Why is my Airwell GC 24 DCI Heat Pump blowing air but not cooling or heating?
If your Airwell Heat Pump's indoor and outdoor fans are working, but there's no cooling or heating, the overload safety device on the compressor may have cut out because of low voltage or high temperature. Also, the compressor run capacitor may be faulty, or the compressor windings may be shorted. Try switching off the power and trying again after one hour, and check for proper voltage. If the problem persists, consider replacing the compressor capacitor or the compressor.
Overview of the SX split ceiling mounted range and its key technological innovations.
Details on the indoor unit, its components, and filtration system.
Information on outdoor unit installation, components, and control system.
Compatibility table for matching indoor and outdoor units.
Technical specifications for the SX 9 DCI model with R410A refrigerant.
Technical specifications for the SX 12 DCI model with R410A refrigerant.
Technical specifications for the SX 18 DCI model with R410A refrigerant.
Technical specifications for the SX 24 DCI model with R410A refrigerant.
Technical specifications for the SX 30 DCI model with R410A refrigerant.
Physical dimensions for SX 9, 12, 18, 24, and 30 DCI indoor units.
Physical dimensions for GC 9, 12, 18, 24, and 30 DCI outdoor units.
Cooling and heating capacity data for SX 9 DCI.
Cooling and heating capacity data for SX 12 DCI.
Cooling and heating capacity data for SX 18 DCI.
Cooling and heating capacity data for SX 30 DCI.
Factors adjusting capacity based on tubing length for SX 9/12 DCI.
Octave band sound pressure levels for SX indoor units.
Octave band sound pressure levels for GC outdoor units.
Electrical parameters for single-phase units, including supply and wiring.
Electrical wiring schematics for SX 9/12/18 DCI and GC 9/12/18 DCI units.
Electrical wiring schematic for SX 24 and 30 DCI indoor units.
Electrical wiring schematic for GC 24 and 30 DCI outdoor units.
Diagrams illustrating the refrigeration circuits for cooling and heating modes.
Guidelines for tubing connections, including bending and torque specifications.
Common issues and their solutions for DCI single split systems.
Procedures for checking system pressures and thermodynamic measures.
How to enter and interpret diagnostic modes for unit troubleshooting.
Simple procedures for checking key components like mains voltage and motors.
Important safety warnings and advice for handling electrical components.
Overview of the DCI software, operation concept, and fan control.
Detailed operation logic for Cool, Heat, and Dry modes.
Explanation of various protection codes and their triggers.
Procedures for entering and operating the unit in test mode.
Model-dependent software parameters for unit configuration.
Diagrams and lists of parts for indoor units SX 9, 12, 18, 24, 30 DCI.
Diagrams and lists of parts for outdoor units GC 9, 12, 18, 24, 30 DCI.
References to separate installation and operation manuals for SX DCI series.
To Next Page
General
