- 19 -
3.After the pairing is successful, the green light ashes quickly. After a few seconds, turn on the wheelchair and enters
the remote control mode. Now the remote control stops ashing, and it lights 0.5s and then goes o.
Push the joystick, it could control the wheelchair to run, stop and turn normally, and the remote control indicator
light goes o, short press the “upper side big button”, the horn sounds, short press the “downside big button”,
the headlights turn on; The green light ashes once every 5 seconds when it is in remote control mode.
Short press button“C”, the wheelchair switches to highest speed (5), and press button“D”, the wheelchair
switches to lower speed (2).
Short press or long press "Power button" and release, the wheelchair joystick light will be o and power o, then
short press or long press "Power button" and release, the wheelchair will automatically turn on within 3~5 seconds;
After the above steps, short press or long press the “power button” and release, the wheelchair will be turned o.
At the moment, press and hold the “B” button, the wheelchair automatically enters the folding mode and starts
to fold, then release the button and short press “B”, the folding pauses . and then short press "A", the wheelchair
will be unfolded. After the expansion is completed, short press the "@" button, the wheelchair exits the folding
mode, the joystick turned o and the light is o.
1.
2.
3.
4.
1.
2.
3.
Short press or long press "Power button" and release, the wheelchair is power on, long press "@" button, after a few
seconds, the red light ashes once, it exits the remote control mode and goes to sleep mode;Short press the “Power
button”, the remote control will wake up, the green light will ash quickly, the remote control will automatically
connect the wheelchair after a few seconds, and the wheelchair will automatically turn on.
After power on, push the Bluetooth remote joystick and release, from now on, about 2 minutes later, the remote
control automatically enters the sleep state, and the red light ashes once.
When the dry battery voltage is lower than 2.1V, the Bluetooth remote control will be in a low battery state, and the
red light will continue to ash.
How to use the blutooth remote control
Bluetooth remote indicator
To Next Page
Loading...
Need help?
General
