29
Power sources
You can power the recorder not only with
alkaline dry battery but also with house
current. You cannot, however, use
manganese dry battery.
When to replace the
battery
You can check the battery condition with
the battery indicator which is displayed
while using the recorder. The battery
indicator changes due to the battery
condition.
The battery level indicator is approximate.
Battery indicator
Battery power decreasing
m
Weak battery
m
The battery has gone out.
“LoBATT” flashes in the
display on the recorder, and
the power goes off.
Note
The battery life may be shorter than that
specified, depending on the operating
conditions, the temperature of the location, and
varieties of a battery.
Using house current
1 Connect the AC power adaptor to DC
IN 3V.
2 Connect the AC power adaptor to the
wall outlet.
Notes
• For use in your house: Use the AC power
adaptor. Do not use an AC power adaptor
other than the recommended one since it may
cause the recorder to malfunction.
• There are regional differences in the supplied
AC power adaptor specifications. For this
reason, you should verify that the power
requirements and plug configuration are
appropriate for your area before you purchase
the recorder.
• Connect the AC power adaptor to an easily
accessible AC outlet. Should you notice an
abnormality in the AC power adaptor,
disconnect it from the AC outlet immediately.
Battery life
1)
The battery life may be shorter due to operating
conditions and the temperature of the location.
Unit: approx.hours (JEITA
2)
)
1)
When using a new Sony LR6 (size AA)
“STAMINA” alkaline dry battery (produced
in Japan).
2)
Measured in accordance with the JEITA
(Japan Electronics and Information
Technology Industries Association) standard.
When SP
stereo
LP2
stereo
LP4
stereo
playing 42 48 56
To wall outlet
AC power
adaptor
To DC IN 3V
Polarity of the
plug
To Next Page
Loading...
Need help?
General
