AJAX DoorProtect Plus User Manual

Sensitivity Sensitivity level of the shock sensor
Ignore simple impact If active, the detector ignores single hit
Tilt sensor If active, sensor will detect tilt
Tilt
Selecting the normal angle of the sensor. Above
this limit, the sensor detects an alarm
Tilt alarm delay
The number of seconds from the moment the
sensor is tilted to the alarm
Always active When turned on, the detector is always armed
External Contact Type
Selecting the type of
Time before alarm, sec
(available for roller shutter motion detector only)
The time in seconds during which a given number
of impulses should be counted. This time is
counted after the first impulse of the detector.
Impulses before alarm
(available for roller shutter motion detector only)
Number of detector impulses required to raise an
alarm
Alert with a siren if opening detected
If active, and are
activated when opening detected
Alert with a siren if an external contact is open
If active, HomeSiren and StreetSiren are activated
during an external detector alarm
Alert with a siren if shock is detected
If active, HomeSiren and StreetSiren are activated
during a shock alarm
Alert with a siren if tilt is detected
If active, HomeSiren and StreetSiren are activated
during a tilt alarm
Jeweller Signal Strength Test
Switches the detector to the signal strength test
mode
Detection Zone Test Switches the detector to the detection area test
Attenuation test
Switches the detector to the signal fade test
mode (available in detectors with firmware
version 3.50 and later)
User Guide Opens the detector User Guide
Unpair Device
Disconnects the detector from the hub and
deletes its settings
external wired
detector
HomeSiren StreetSiren

AJAX DoorProtect Plus Specifications

General

Brand	AJAX
Model	DoorProtect Plus
Category	Security Sensors
Language	English