Akai 4000DS

22.
23.
24.
‘2s.
27.
28.
RECORDING SAFETY BUTTON
S.0.S (Sound-On-Sound) BUTTON
See Sound-On-Sound Recording procedure.
TAPE SELECTOR SWITCH
Normal: For regular tape; S.R.T: For Akai’s Super Range
Tape or other make low noise tape.
EQUALIZER SWITCH
Must be set to correspond with tape speed. See Tape Speed
Selection procedure.
MONITOR SELECTOR SWITCH (Tape & Source)
During recording. mode when the Monitor Selector Switch is
set to TAPE position, signals can be monitored as the tape
passes the playback head. When set to SOURCE position, the
program source will be monitored. For erasing or private
listening during playback mode, the Monitor Selector Switch
should be at TAPE position.
RECORDING LEVEL CONTROL (Right)
Outer Control: Line ; Inner Control: Microphone.
AC CORD
29.
30.
31.
32.
- leve¥ of the amplifier is low.
CYCLE CONVERSION SWITCH (B)
This Switch and the Cycle Conversion Switch (A) must be set
to correspond with area power source.
UNIVERSAL VOLTAGE SELECTOR & FUSE POST
See Voltage & Cycle Conversion procedure.
LINE INPUT JACKS (Left & Right)
Connect to output jacks of external source.
DIN JACK
Enables inter-connection with an external amplifier by means
of a single Din cord. Use instead of Rec. or P.B. Jacks. Note
that when using Din cord, the recording level is controlled with
the Microphone Recording Level Controls.
LINE OUTPUT JACKS (Left & Right)
Connect to tape in or aux jacks of external amplifier for
playback. .
DIN JACK HIGH/LOW INPUT SELECTOR ree
en yising Din/Jack for epee with an external plifier,
set thjs Switch/to HIGH position when the optput level of the
ee is High, and fo a hen pre output
position