Akai AP-M7

i
,
5-3.
DESCRIPTION
OF
LED
DISPLAY
LED Display
Description
Function
START/CUT
“OFF” while Main Motor is OFF.
(not turning)
“ON” while Main Motor is ON
and also Servo Lock is ON.
Flickering when Main Motor is
ON and turning but out of Servo
Lock.
LED starts flickering and changes to steady lighting
after S/C button is depressed.
LED lights in the same way as above when the speed
is changed (33 > 45 or 45 > 33) while the Main
Motor is Turning.
UP
“ON” while Tone Arm is up.
LED
indicates
POWER-ON
as
well,
since
Tone
Arm
is
always
up
when
the
power
is
turned
on.
DOWN
“ON” while Tone Arm is down.
LED is lit while the stylus is on the record.
REPEAT
“ON” while REPEAT is engaged.
LED is not lit in MANUAL mode.
REPEAT will be concelled if the Dust Cover is
opened or the $/C button is depressed during repeat
operation.
SPEED 33
“ON” while 33-1/2 rpm is
selected.
LED
indicates
POWER-ON
as
well,
since
33-1/3
is
pre-set
when
the
power
is
turned
on.
SPEED 45
“ON” while 45 rpm is selected.
LED
will
be
extinguished
if
the
Dust
Cover
is
opened,
and
the
33-1/3
LED
will
be
lit
instead.
SIZE 30
“ON” while a 30 cm record is
on the platter.
LED
lights
up
after
the
record
size
is
detected
and
remains
on
until
the
Dust
Cover
is
opened.
(See
Note
1)
SIZE 17
“ON” while a 17 cm record is
on the platter.
The same function as SIZE 30. (See Note 1)
SIZE 30/17
in MANUAL
mode
“Flickering” when START
Button is depressed, also if the
Tone Arm is up, and away from
the Arm Rest.
Flickering
Indicates
that
Auto
Lead-in
&
Size
Sensors
are
not
executed
in
Manual
mode.
NOTE.
1.
Refer
to
the
description
of
SIZE
LED
DISPLAY
in
this
section.
SERVICE
MANUAL
AP-M7
[8S
10