6
CASSETTE TAPE/ AUX IN OPERATION
CASSETTE TAPE OPERATION
1. Adjust the Function switch to TAPE position.
2. Insert a cassette tape into tape slot, with the exposed side facing right. The cassette will slide into
the tape mechanism by pushing and start playing automatically. One end of the tape will remain
visible when it’s playing.
3. Adjust volume control to your desired sound level.
4. Depress the eject button completely in, the tape will be ejected from the slot.
5. Press the eject button half way to fast forward of the tape you are listening.
6. The tape will stop automatically when it comes to its end.
AUX IN OPERATION
1. Adjust the Function switch to AUX position.
2. Connect this unit with your audio device by an audio cable.
3. Play the music on your audio device.
4. Adjust volume control to your desired sound level.
5. The external audio sourcing can be played by this jack.
Cassette Recording& AUX IN Recording
1. Set the function switch to TAPE/ AUX mode and insert a memory device (USB disk or SD card).
2. Insert a cassette into the slot and play, or play the external audio sourcing according to the steps
above.
3. Press the REC button when it’s playing.
4. This unit will start recording.
5. To finish recording, press the STOP button.
6. Your files will be stored in SD card by default if you insert both USB disk and SD card.
7. Press and hold the REC button for 2 seconds during your recording, it can switch between USB disk
and SD card.
8. The file you recorded from AUX IN will start with “TAPE”.
To Next Page
Loading...
