Akai ATT-15C

7
USB/SD/BT PLAYING
PLAYING MUSIC FROM USB/SD DIRECTLY:
1. Make sure the power is on, insert USB disk/ MP3 player into USB port and/or insert memory card
into SD socket.
2. Adjust function switch to USB/SD/BT position, press SOURCE button to choose music source
between USB and SD if you insert both of them.
3. The device supports for MP3 formats. Press PLAY/PAUSE button once to halt playing when it’s
playing, press it again to continue.
4. Press PREV once to play the previous song, hold this button to speed up backward. Press NEXT
once to play the next song, hold this button to speed up forward.
5. Press FOLDER+ button, the unit will play the files in the folder you choose.
6. Press STOP to end up the play.
PLAYING MUSIC FROM BT:
1. Adjust function switch to USB/SD/BT position, press SOURCE button to choose music source BT.
2. Search the Bluetooth name “ATT-15C” and pair with it.
3. You could play your music now.
NOTE:
The device does not support for transit music files between SD and USB.
LISTEN TO THE RADIO
1. Use the function switch to select TUNER mode.
2. Use the radio band switch to select the desired band (AM, FM or FM-Stereo).
3. Press and hold the PLAY/PAUSE button for 2 seconds, this unit will search and store the radio stations
automatically.
4. Turn the tuning knob to tune into a radio station you desired if the signal is weak and can not be stored
by auto-search.
5. Adjust the FM antenna or move the unit to a new place until the signal is strong enough.
6. Then repeat step 3, the radio station you desired will be found.
7. Adjust the volume knob to your desired volume level.
8. When you have finished listening to the radio, turn the volume knob in a counterclockwise direction to
power off this unit. Unplug it from the power supply if you are not going to use it for a while.
FM and FM-stereo Band
FM: Use the radio band switch to select the FM. Stations/ programs are received in mono mode. Use this
mode when stereo reception is weak.
FM-Stereo: Use the radio band switch to select FM-ST for receiving stereo station/ programs. Once a
stereo signal is received, the STEREO icon will light up on the display.
NOTE:
1. AM reception: The receiver has a built-in AM bar antenna. If reception is weak, slightly rotate or
reposition the unit to improve AM reception.
2. FM reception: The receiver has a built-in FM wire antenna hanging at the rear of the cabinet. For best
reception, completely unravel and extend this wire.