Akai ATT-15C

5
OPERATION INSTRUCTIONS
PHONO OPERATION
1. Use the function switch to select PHONO mode.
2. Set the speed selector to the appropriate position: 33, 45 or
78rpm according to the vinyl to be played.
3. Set the auto-stop switch to ON position if you want the
turntable to stop turning when it has reached the end of the
record. If the switch is set to OFF position, the turntable will
keep turning at the end of the record.
4. Place the record on the turntable (use the 45RPM adaptor, if required).
5. Unlock the arm clip and set the lift lever to the up position to raise the tonearm from the arm rest,
then move the tonearm to the record slowly, as illustrated above. The platter will start rotating.
6. Move the tonearm lift lever to the down position, the tonearm will gently move onto the record and it
will start to play.
7. To play a different track on the record, set the lift lever to the up position to raise the tonearm, move
the raised tone arm to the start of the track and then move the lift lever to the down position, it will
start to play a new track.
8. Adjust the volume, turn the volume knob to the right or left.
9. When you have finished playing records, lift the tonearm off the record and return it to the arm rest
manually. Lock the tonearm clip to protect it from any accidental movement. Turn the volume knob in
a counterclockwise direction to turn off the unit. Unplug it from the power supply if you are not going
to use it for a while.
NOTE:
If your record player stops playing before the last track is finished, set the auto-stop switch to OFF. Your
record will play to the end now, but you have to stop the turntable rotation manually. (Return the tonearm
to its rest manually and the platter is still rotating, turn off the unit by the volume control knob.)
Phono Recording
1. Set the function switch to PHONO mode and then insert a memory device (USB disk or SD card).
2. Put your record onto the platter and get it ready for playback.
3. Press the REC button when it’s playing.
4. This unit will start recording.
5. To finish recording, press the STOP button.
6. Your files will be stored in SD card by default if you insert both USB disk and SD card.
7. Press and hold the REC button for 2 seconds during your recording, it can switch between USB disk
and SD card.
8. The file you recorded from Phono will start with “PH”.
NOTE:
·The recording speed is 1:1. Recording will take as long as playing the record.
·The recording format is preset at MP3 bit rate 128kbps.