Switching On for the first time
Plug into AC power or install batteries by following instructions on the previous Power
Connection section. Slide the FUNCTION switch to RADIO or CD/AUX positionDŽThe
POWER indicator will be lighted up.
Switching between different sources (Radio –CD/AUX)
After turning on the unit, slide the FUNCTION switch to select different sound sources
Adjusting sound volume level
After turning on the unit, turn the VOLUME knob to adjust the level of sound volume.
Adjusting the rod antenna
The aerial should be extended to ensure good reception in both FM radio modes. It may be
necessary to adjust the position of the unit and /or aerial position to achieve the best signal
reception.
Bass booster
During music playback, toggle the BASS button to turn on/off bass booster for bass
enhancement.
The unit is designed to play normal music CD disc bearing the correct identification logo. If
the disc does not conform to the standard, it may not be played back properly.
Loading disc
1. Slide the FUNCTION switch to CD/AUX position to turn on the unit.
2. Access the OPEN AREA on the top panel to flip the CD door open.
Caution:
• Playback of CD-R / CD-RW may depend on recording conditions.
• Do not attach a seal or label to either side (the recordable side or the labeled side) of a
CD-R/ RW disc. It may cause malfunction.
• Do not load a blank CD-R/ RW disc. It will take over 1 minute to read the disc. The disc
may be damaged if you try to open the CD Door while reading the disc.
• CD-ROM
To Next Page
Loading...
