Akai CS-F14

V.
VOLTAGE
AND
CYCLE
CONVERSION
POWER SUPPLY PCB VOLTAGE SELECTOR
T2027 B5020 VS |
POWER TRANS
FRONT
Fig. 7 Voltage Conversion (U/T Model only)
1. VOLTAGE CONVERSION 2. CYCLE CONVERSION
Models for Canada, Europe, USA, UK and Australia With DC motor, cycle conversion is not necessary.
are not equipped with this facility.
Each machine is preset at the factory according to
destination, but some machines can be set to 110V,
120V, 220V or 240V as required.
If voltage change is necessary, this can be accom-
plished as follows:
1) Disconnect power cord.
2) Loosen holding screws and remove upper cover.
3) Remove short pin plug from present holes and
replace in correct holes. Follow the markings
explicitly.
|
|
'
|
4
:
{
GMI In i il ah i SS Sep pk int cha as neem i a tt
ee ORE Rac PS OE, a I Pn RP Oe A I PTO SIN ORR PEN Sega Ss NC eee OP PST EPO TENT PTS, Sree ee