Akai CS-F14

1. SPECIFICATIONS
TRACK SYSTEM
4 Track 2 Channel Stereo System
TAPE
Philips Type Cassette
TAPE SPEED
4.76 cm/s + 1.0% (1-7/8 ips. + 1.0%)
HEADS
High Density Metallic Head for recording/
playback x 1
Erase Head x 1
MOTOR
Electronically speed controlled DC motor
WOW & FLUTTER
Less than 0.04% WRMS, 0.10% (DIN 45500)
TAPE WINDING TIME
90 sec. using a C-60 cassette tape
FREQUENCY RESPONSE
Normal: 30 to 15,000 Hz + 3 dB (—20 VU)
20 to 17,000 Hz
CrO,: 30 to 16,000 Hz +3 dB (—20 VU)
20 to 18,000 Hz
Metal: 30 to 18,000 Hz + 3 dB (—20 VU)
20 to 19,000 Hz
SIGNAL TO NOISE RATIO
Normal: Better than 56 dB
CrO,: Better than 58 dB
Metal: Better than 58 dB
(measured via tape with peak recording level)
Dolby C-type NR ON: Improves up to 15 dB at
500 Hz, 20 dB at 1 kHz to 10 kHz
Dolby B-type NR ON: Improves up to 5 dB at
1 kHz, 10 dB above 5 kHz
HARMONIC DISTORTION
INPUT
OUTPUT
DIN
Normal: Less than 0.8%
CrO,: Less than 0.8%
Metal: Less than 0.8%
MIC: 0.25 mV (input impedance 5.0 kohms)
Required microphone impedance: 600 ohms
Line: 70 mV (input impedance 47 kohms)
Line: 410 mV at0 VU
Required load impedance: more than 20 kohms
phone: 0.3 mV/8 ohms at 0 VU
Input: 2.0 mV (input impedance 10 kohms)
Output: 410mV
Required load impedance: more than 20 kohms
POWER REQUIREMENT
AC 120V, 60 Hz for USA and Canada
AC 220V, 50 Hz for Europe except UK
AC 240V, 50 Hz for UK and Australia
AC 110V/120V/220V/240V, 50/60 Hz switchable for
other countries,
POWER CONSUMPTION
DIMENSIONS
440 (W) x 103 (H) x 273 (D) mm
(17.3 x 4.1 x 10.7inches)
WEIGHT
4.1 kg (9.1 Ibs)
* For improvement purposes, specifications and design are subject to change without notice.
*“Dolby” and the Double D symbol are trademarks of Dolby Laboratories
(Manufactured under license from Dolby Laboratories.)
|
}
LN a RN ee ee pore aE EE ENS Pe Fe eRe ey