Akai EWV2000 User Manual

12
Saving One Bank at a Time
With the EWV2000, it is possible to save one bank at a time. The
procedure is basically the same. First press the SAVE button.
The display will read:
This refers to bank "1". If the SAVE button is pressed again, the
voice data stored in bank 1 is recorded onto the tape.
BANK NUMBER
These voice data are saved.
M$
Check that the pre-programmed voice data has been saved properly
onto the tape.
1) Connect the mini-plug to the earphone jack on the cassette tape
recorder and connect the other side to the TAPE IN jack on the
EWV2000. Turn the MEMORY PROTECT switch off, then
press the TAPE button.
Rear panel of EWV2000
T»Pt PflOT
OUT IN ON
Mini-plug
Cassette tape recorder
2) Press the VERIFY button on the EWV2000.
TAPE:VERFY ALL
When the above appears on the display, set the playback volume
control on the cassette tape recorder to about the middle. If the
recorder is equipped with a tone control, set it to high or maxi
mum.
3) Press the VERIFY button again.
TAPE:VERFY STRT
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html

Akai EWV2000 Specifications

General

Brand	Akai
Model	EWV2000
Category	Recording Equipment
Language	English