Akai EWV2000 - Parameter Editing - OSC Section; OSC-1 Frequency and Fine Tuning; OSC-1 Waveform and Pulse Width

17
Creating Sounds
With the EWV2000, it is possible to create a variety of different
sounds by recalling the parameters on the 16-character LCD and set
ting their values. Changing the voices already stored in the memory to
create new sounds is called editing.
For your reference, the following table describes the various parame
ters and their relation to the sound. (Page 18—25)
The EWV2000 is set to the PLAY mode when the power is turned on.
To edit voices or create new sounds, press the EDIT button and set to
the EDIT mode.
Operation:
Display:
Turn the power on.
PI 1 : —<AKA I >~
t
Indicates the PLAY mode.
Operation:
EDIT
Press the EDIT button.
Display:
OSC-1 FREQ
XX
The EWV2000 is in the edit mode, and a parameter is displayed. If
set to the EDIT mode directly after the power is turned on, the
above parameter is displayed.
It is simple to edit and to create new sounds on the EWV2000 if the
parameters are fully understood. Recall the parameters, change the
settings, and listen over speakers or headphones to how the sound
changes.
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html