Akai EWV2000 - Specifications; Technical Specifications Overview; Detailed Parameter List

43
Parameter Copy Function
The EWV2000 is equipped with a convenient function by which the
source 1 side parameters can be copied onto the source 2 side (or vice
versa) in the EDT mode.
Procedure
Example: Copying the source 1 VCF EG parameters onto the source
2VCFEG
(1) First, set to the EDIT mode.
(2) Hold in the source 1 VCF EG button and press the source 2 VCF
EG button. The display will flash, and when copying is completed,
the source 2 LED will light.
(SOURCE 1>
3
□
(SOURCE2)
VCF EG
□
Hold in-
Press
This parameter copy function will only work for items common for
both the source 1 and source 2 parameters. Thus, the FREQ, FINE,
WAVE, PULSE WIDTH, and OSC EG data for OSC can be copied
between source 1 and source 2.
This copy function can be used to set the same voices for source 1 and
source 2, or to transfer the source 1 (or source 2) voices onto source 2
(or source 1).
NOTE: The copy function will work for OSC, VCF, VCF EG, VCA
EG, LEVEL, and BREATH INTENSITY, but not for
VIB/BEN, CHORD, EFFECT, or LABEL.
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html