Akai EWV2000 User Manual

14
Playing the Pre-programmed
Voice Data, «-.'■■ v; ->^ r- •■. • ;<v
Variois voices have been stored in the EWV2000's 64 memory banks
upon shipment from the factory. Each bank number has a voice name.
Now try playing the various voices.
Procedure
(1) Make sure the EWV2000's power is off.
(2) Connect the EWI1000 or EVI1000 controller to the EWV2000
using the exclusive control cable included with the controller.
(3) With your finger on the controller's glide plate, turn the
EWV2000's power on, and press the AUTO TUNE button. The
EWV2000's VCOs and VCFs are now automatically set to the op
timum tuning.
(4) First, adjust the BREATH control knob. Without blowing into
the mouthpiece, turn the outer BREATH control knob clockwise
to the point where the LED lights, then turn the knob slightly
back counterclockwise so that the LED turns off. The adjustment
has now been completed.
(5) Next, adjust the GLIDE control knob. Without touching the
glide plate for the EWI1000, and without blowing into the mouth
piece for the EVI1000, adjust in the same way as for the
BREATH control knob.
(6) Now adjust the BEND control knob. Without touching the con
troller's bend plate, adjust in the same way as for the GLIDE con
trol knob.
(7) When the BREATH, GLIDE, and BEND control knobs have
been adjusted, check that the LINE OUT jack on the EWV2000 is
connected to an amplifier or mixer. To listen with headphones,
connect stereo headphones to the PHONES jack, and adjust the
output level with the LINE OUT knob.
(8) Select a voice. The EWV2000 is designed so that the voice
memory banks and numbers can be switched by using the
VALUE UP and DOWN keys and BANK and NUMBER but
tons on control panel or by using the foot switch.
Switching with the VALUE UP and DOWN keys
■VALUE
DOWN
UP
The bank number increases by one
each time the UP key is pressed.
Ex: 1 1 =012«=J> 13={> 14=015=$16«=M7=$>18c=>> 21={> 22=^23
TT
Bank Number
VALUE
The bank number decreases by one
each time the DOWN key is pressed.
Switching with the BANK and NUMBER buttons
1
BANK
o
source 11 I *■ First select the bank,
osc
□
SOURCE2 I I *" Next select the number.
Ex.: To select "81"
osc
□ ' □
EFFECT
T T
CD- Select the bank. @- Select the number.
Switching with the foot switch
It is possible to switch the banks and numbers both up and down using
two foot, switches and a stereo cord with a stereo phone plug and two
standard phone jacks (available in stores). Or, with one foot switch it
is possible to switch the banks and numbers up only.
(9) When a bank and number are selected, the bank number and
voice name appear on the display (LCD).
Pit: —<AKAI> —
' Numhflf I
Voice name — 10 characters
-Bank
' Indicates PLAY mode
(10) Blow into the mouthpiece and play the controller.
Adjust the BREATH SENSE knob so that playing is comforta
ble.
BREATH
ADJUST"®- SENSE
When the knob is turned to "0", it is
only possible to play by blowing hard.
At "10", sound is produced even
when you blow lightly. Adjust the
BREATH SENSE knob according to
your "breath power".
Ex: 23=fr22c={>21=i>18.={>17=M6«=0i5^>14=i>13=!>12=t>11
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html

Akai EWV2000 Specifications

General

Brand	Akai
Model	EWV2000
Category	Recording Equipment
Language	English