151
To adjust the effect’s parameters, tap the pencil icon. Use the sliders to set the value of each parameter. These
values affect only this instance of the effect; insert effects are not global.
To load an effect preset, tap the folder icon next to the preset name at the top of the display to open the file browser.
To save a new effect preset, tap the disk icon next to the insert selector at the top of the display.
Sends
The audio of the pad will be routed to send effects (if you have any loaded) at their designated send levels. The return
channels will then send the audio to an assigned master output at the designated return levels.
Use the Send knobs to set the volume level of the signal the pad will route to each send effect.
Important: To learn about send effects, please see General Features > Effects > Send/Return Effects.
To Next Page
Loading...
