Akai FORCE

70
Metronome (Click/Metro)
The Click/Metro window contains all settings regarding the metronome (click track).
To open the metronome settings, press and hold Shift and press the track 5 Track Assign button.
Use the Count-In field to set if/when the metronome counts before recording.
• Off disables the metronome pre-count.
• Record enables the pre-count during recording only.
• Record + Play enables pre-count in both Record and Playback Modes.
Use the Enable field to set if/when the metronome is enabled.
• Off disables the metronome.
• Play enables the metronome sound during playback only.
• Record enables the metronome sound during recording only.
• Record + Play enables the metronome to happen in both Record and Playback Modes.
Use the Rate field to select the metronome click’s time division: 1/4, 1/4T, 1/8, 1/8T, 1/16, 1/16T, 1/32 or 1/32T.
T indicates a triplet-based time division.
Use the Sound field to select the sound that you want to hear for the metronome: Sidestick 1, Sidestick 2, Clap,
Metroclick, Shake, Tambourine, or Force Click.
Use the Volume knob to set the volume of your metronome click.
Tap the On/Off butt
on to enable or disable the metronome.
Use the Output field to set which pair of outputs will play the metronome click: Out 1,2, Out 3,4 or an individual Out
1–4.