72
Arpeggiator
Force includes a full-featured arpeggiator and phrase player for melodic track types, as well as traditional note repeat
functionality.
To enable the arpeggiator, press the Arp button.
To configure the arpeggiator setting, hold Shift and press the Arp button to open the Arpeggiator window.
The Setup section of the Arpeggiator window sets what kind of arpeggiator will be used and its basic functions.
Use the Action field to set the type: Arp, Note Repeat, Rhythm and Pattern. See below for more details about
these types and their additional parameters.
Use the Time Division selector to set the note value of each arpeggiator step from 1/1–1/64 beats, including T
(triplet) variations. This parameter is not available when Action is set to Pattern.
Note: This setting is tied to the project's Time Division setting, and will not function if Time Division has been set to
Off.
Use the Note Length slider to set the length of the played note in each step, from 1–100%.
Use the Velocity field to set the velocity of the arpeggiator notes. Choose As played, From first note, Accented,
Full, 3/4, Half or 1/4.
Use the Swing field to set the amount of swing in the arpeggiator from 50% to 75%. Swing lets you "shuffle" your
beats—from subtle to extreme.
To Next Page
Loading...
