84
Plugins
Force includes four new plugins from AIR Music Technology to help you get started making music right out of the box.
To learn more about plugin tracks, see Operation > General Features > Tracks > Plugin Tracks.
Bassline
The AIR Bassline plugin emulates the sound of classic mono synths,
with a contemporary twist.
Osc / Filter / Envelope
Use this tab to adjust the settings for the oscillators, as well as their
filter and envelope settings.
Parameter Description
alue Range
Oscillato
Waveform Continuously variable waveshape for the oscillator. Saw Octave, Saw, Square, Sine
Sub-Octave
mount of sub-octave oscillator. 0–100%
Fifth
mount of fifth-oscillator. 0–100%
Start Phase Position of the waveform when a note is triggered. Free, 0 degr., 180 degr.
Glide Time
mount of time to slide from the pitch of one note
to the next note played.
10.0 ms – 2.00 s
Boost Boosts the signal of the oscillator. 0.0 dB – 48.0 dB
Boost Freq. Center frequency of the boost. * 1.0 – * 240.0
Boost Envelope
mount of effect of the envelope on the Boost
section.
Adjust Gain to control the amount of boost.
Adjust Frequency to control the width of the
boosted frequency.
Gain 100–0%, Off, Frequency
0–100%
Filte
LP Cutoff Cutoff frequency for the low-pass filter. 20.0 Hz – 20.0 kHz
Reso Resonance of the filter. 0–100%
Filter Env Envelope of the filter.
At negative values, decreases the cutoff value
based on the filter decay value.
At positive values, increases the cutoff value
based on the filter decay value.
-100% – 0 – 100%
HP Cutoff Cutoff frequency for the high-pass filter. 10.0 Hz – 500 Hz
Envelope
mp Attack Length of time for the note to reach full volume. 100–0% Soft to 0
100% Hard
mp Decay Length of time for the note to reach the sustained
volume.
0–100%
Filter Decay Length of time for the filter to reset after being
released.
0–100%
Pitch Mod
mount of pitch modulation applied to the
envelope.
0–100%
To Next Page
Loading...
