85
Velocity / Master / Chorus
Use this tab to adjust the Velocity Control settings, Master volume. You can also apply and adjust the settings for the
built-in Chorus effect.
Parameter Description
alue Range
elocity
mp Control The amount of effect velocity has on amplitude
control.
0–100%
Filter Control The amount of effect velocity has on filter control. 0–100%
Boost Control The amount of effect velocity has on boost control. 0–100%
Env Retrigge
Sets whether the envelope will retrigger when a note is
played while another note is being held.
Off, On
Maste
Master Volume Sets the volume level. -inf dB – +6.0 dB
Drive Type Choose one of two drive algorithms. Overdrive, Clip
Drive Amount
mount of drive applied. 0–100%
Bend Range Number of semitones up or down controlled by MIDI
pitch bend messages
0–12
Chorus Rate Modulation speed of the chorus effect. 0.40 Hz – 3.20 kHz
Depth Modulation depth of the chorus effect. 0–100%
Mix Wet/dry amount of the chorus effect. 0–100%
On/Off Enables or disables the effect. Off, On
Delay
Use this tab to apply and adjust the settings for the built-in delay effect.
Parameter Description
alue Range
Time Length of time of the delayed signal.
When Sync is set to Free:
1 ms – 2.00 s
When Sync is set to Sync:
1/32 – 8/4
Sync
Set to Free to adjust Time by milliseconds, or set to Sync to match the
Delay Time to the Global Tempo.
Free, Sync
Mix Wet/dry amount of the delay effect. 0–100%
Feedback
mount of signal fed back into the delay line. 0–100%
Damp Center frequency of where the delay signal will be dampened. 1.00 – 20.0 kHz
Reso
mount of resonance of the feedback signal. 0–100%
Reso Freq Center frequency for feedback resonance. 100 Hz – 10.0 kHz
Ratio
Reduces the delay Time in either the Left or Right stereo field. This is
useful for creating offset, panned delays.
L 50:100, R 50:100
HPF Center frequency for delay signal high-pass filter. 20.0 Hz – 1.0 kHz
Width Stereo width of delay signal. Higher values give wider stereo separation. 0–100%
On/Off Enables or disables the effect. Off, On
To Next Page
Loading...
