86
Compressor / Hype
Use this tab to apply and adjust the settings for the built-in Compressor and Hype effects.
Parameter Description
alue Range
Compresso
Threshold Signal level after which the compressor will be applied. 0.0 – -60. dB
Ratio
mount of compression applied. 1.0:1 – 100.0:1
Output
mount of additional output gain for the compressed
signal.
0.0 – +30.0 dB
Mix Wet/dry mix of the compressor effect. 0–100%
Knee How gradually the compressor reacts as the threshold
is reached.
Lower values apply a "soft" knee (compression is
applied more slowly as signal approaches the
threshold), and higher values apply a "hard" knee
(compression is immediately applied when the
threshold is reached).
0–100%
ttack Length of time to apply the compression. 100 us – 300 ms
Release Length of time for compressed signal to return to
original level.
10 ms – 4.00 s
On/Off Enables or disables the effect. Off, On
Hype High Dampens or maximizes high end frequencies. -100 – 0 – +100%
Low Dampens or maximizes low end frequencies. -100 – 0 – +100%
On/Off Enables or disables the effect. Off, On
To Next Page
Loading...
