Akai FORCE

209
When a Drum Track is selected, and Type is set to Pad:
Mixer: Off, Level, Pan, Pad Mute, Pad Solo, Send 1–4
Trac
k
:
Off
A
mp Env Hold Layer Sample Pan (1
–
4) LFO to Filte
r
V
elocity to Amp
Tuning
A
mp Env Sustain Layer Semi Tune (1
–
4) LFO to Amp
V
elocity to Pan
Filter Cutoff Filter Env Attack Layer Fine Tune (1
–
4) LFO to Pan Layer Direction (1
–
4)
Filter Resonance Filter Env Hold
V
elocity to Start LFO Wave Layer Offset (1
–
4)
Filter Env Amount Filter Env Decay
V
el to Filter Attack LFO Rate
A
mp Env Attack Filter Env Sustain
V
elocity to Env Amount LFO Sync
A
mp Env Decay Filter Env Release
V
elocity to Filte
r
V
elocity to Pitch
A
mp Env Release Layer Level (1–4) LFO to Pitch
V
el to Volume Attack
Insert 1–4: Off, other available parameters depend on the effect
When a Keygroup Track is selected:
Mixer: Off, Volume, Pan, Mute, Solo, Send 1–4, Crossfader route, Cue bus enable
Track: Off, Master Semi Tune, Master Fine Tune
Insert 1–4: Off, other available parameters depending on the effect
When a Plugin Track is selected:
Mixer: Off, Volume, Pan, Mute, Solo, Send 1–4, Crossfader route, Cue bus enable
Track: Off, other available parameters depending on the plugin
Insert 1–4: Off, other available parameters depending on the effect
When a MIDI Track is selected:
MIDI CC: Standard MIDI control change assignments
When a CV Track is selected:
Mixer: Off, Mute, Solo
Track: Off, CV Out 1–4
When an Audio Track is selected:
Mixer: Off, Volume, Pan, Mute, Solo, Send 1–4
Insert 1–4: Off, other available parameters depending on the effect
To reset all changes, press the Reset button.