34
To configure the pads in Note Mode, hold Shift and press Note to
open the Note Config window. In this window, you can set the
function of the pads, from playing notes in a scale to playing full chord
progressions. For now, let's leave Type set to Scales and set Pad
Rows to Start on root.
See Operation > General Features > Pad Modes > Note Mode to
learn more.
Now, let's prepare the clip and track for recording:
1. Create an empty clip in Track 6 – Classic Bass following the
directions above.
2. Launch the clip to make sure it is playing.
3. Press the Rec Arm button, then press the sixth Track Select
button to record enable the track. A record symbol will appear
under the track name.
4. Finally, when you are ready to record, press the Rec button. On
the display, the selected clip will turn red and show Overdub.
5. Try recording a simple bassline using the clip launch pads in
Note mode. Press Undo at any time to undo any recorded note
events.
6. You have finished recording, press the Rec button again to stop
recording.
You can also change the recording configurations to suit your
preferences.
1. Press Matrix to open Matrix Mode on the display.
2. Hold Shift and press Record to open the Record Configuration
window.
3. Check the Write automation when recording box to capture
automation while recording.
Use t
he Record Mode field to set how recording is initiated.
When set to Pad, tap any pad while the track is armed to begin
recording. When set to REC Button or Pad, tap any pad while the
track is armed to begin recording, or press the Record button to
begin recording on the highlighted clip slot. When set to REC
Button then Pad, first press the record button, then tap any pad
to begin recording. This is the default mode when Force is
powered on.
Check the Fixed Length Recording box to stop recording after
the clip length set in the Fixed Length (Bars) field. Leave
unchecked to record for any desired clip length.
Use the Record To field to set the behavior when recording is
completed, entering either Overdub or Play.
4. When you are finished, tap Close to close the Record
Configuration window.
To Next Page
Loading...
