Akai GX-65 MKII

Troubleshooting : __
SS
aa
wer cord is not connected properly.
n
Check the power cord connection.
@ Da
Fr Ty
No power.
@ Improper connections.
Check that the connection cords are properly connected.
@ The connected amplifier’s input selector is not set prop-
erly. ;
Check the input selector.
@ The tape monitor switch is not set properly.
Set the switch to SOURCE or TAPE by pressing the MON-
ITOR button.
@ The TIMER START switch is set to REC or PLAY.
Set the switch to OFF.
The cassette tape’s recording defeat tabs are removed. |
Cover them with adhesive tape.
The !@ button is not pressed.
Press the te! button.
The & button is not pressed.
Press the > button.
The REC LEVEL controls are set too low. :
Increase the recording levels with the controls.
Recording ievels are set too high.
Decrease the recording levels with the control.
@ The noise reduction selector is not set properly.
Reset it.
@ The recording and playback heads are dirty.
Clean the heads.
The Noise reduction selector is not set properly.
Set the switches according to how the tape was recorded.
@ The MPX FILTER switch is set to m.
Set the switch to = before FM broadcast recording.
@ The BIAS control is not adjusted properly.
Adjust the BIAS control properly before recording.
@ Dirty heads, capstans, tape guides or pinch rollers.
Clean all tape transport mechanism parts.
@ The memory stop system is engaged.
Press the MEMORY button to turn it off.
@ The end of the tape is reached.
Turn over the tape or press the opposite operation button
<4 or PP button for example.
© The memory system is not engaged. i:
Press the MEMORY button to turn on the memory system.
® The > button and <4 buttons were not pressed simul-
taneously.
Press the ® and <4 buttons simultaneousely.
No sound.
The stereo cassette deck goes into recording or play-
back when the power is turned on.
Recording will not take place.
Distorted recording or playback.
? High frequency sounds are stressed during playback.
Low and middle frequency sounds are stressed during
playback.
Wow and flutter in the sound.
Tape stops automatically during tape winding.
Playback will not start automatically from the “0000”
position of the tape counter.
———)
Should
a
problem
persist
write
down
the
model
and
serial
number
and
all
pertinent
data
regarding
warranty
coverage
as
well
as
a
clear
description
of
the
existing
trouble.
Then
contact
your
nearest
authorized
Akai
service
station.