Akai VS-2EGN

2. BACK TENSION ADJUSTMENT
HOLDER TENSION SPRING PLATE
ADJUTMENT
SCREW
LEVER TENSION
AKA\I vis
gf-cm|
BACK TENSION
Neel CASSETTE G:
Fig. 8-3
1) Set the back tension adj. jig (AJ-751181) shown in
Fig. 8-3 and achieve PLAY mode.
2) Loosen the adjustment screw shown in Fig. 8-2 adjust
the holder tension spring plate so that back tension
will be 20 gf-cm, and tighten the adjustment screw.
3) After adjustment, paint-lock the adjustment screw.
‘Service Manual VS-2EGN—
99