Akai VS-2EGN

3. AUDIO/CONTROL HEAD HEIGHT, TILT
AND AZIMUTH ADJUSTMENT
NO GOOD
“N=— VIDEO TAPE Nosege.
Fig. 10-6
AUDIO HEAD
AUDIO ERASE HEAD.
04 10 0.5mm Go0p
) VIDEO TAPE
Fig. 10-8
CONTROL
HEAD
Fig.
10-7
1) Connect an AC Volt Meter to Audio Out.
2) Playback the reference tape AT-750795.
3) Turn screw (a), (b) and (c) in order slightly but
by exactly the same amount. Adjust the audio
output level to its maximum. “Take screw (a) as
your standard and use screw (b) for azimuth
adjustment. Adjust screw (c) until there is no tape
wrinkle in the guide pole section, the audio output
level is at maximum and there is the minimum
possible level fluctuation.
Then raise and lower screw (a) very slightly and
adjust (b) and (c), and set to the point for maxi-
mum output.
NOTE: Repeat the adjustment of tape guide height,
guide roller height and audio/CTL several times
in order to achieve the perfect tape running.
Service Manual VS-2EGN
103