Akai VS-2EGN

Vi. VOLTAGE CONVERSION
POWER
:
ON OFF
AC INPUT —
[asm nov |
(ee g
110/220
50Hz~
pana
2)
~“@})
CONVERTER
ay
|
RF
ICH. ADJ. HOLE
Fig. 6-1 Voltage Conversion
Power requirements for electrical equipment differ from
area to area. The operating voltage of VS-2EGN is pre-
set to 220V. Before connecting, check that the AC IN-
PUT selector on the rear panel is set to the voltage for
your area:
110V, 50 Hz for other countries. If the AC INPUT is
not set for your area:
1. Confirm that the POWER Switch on the rear panel
is set to OFF.
2. Confirm that the POWER Cord is disconnected.
3. Move the AC INPUT selector with a screwdriver so
that the marker is above the voltage for your area.
Service Manual VS-2EGN