Akai VS-2EGN

Refer to Fig. 7-5 Recording/Playback Function of VS-2
Recordable TV signals from built-in tuner
PAL B/G
SECAM B/G
Recordable TV signals from line input
PAL B/G/H/I
SECAM B/G (Middle East SECAM)
SECAM L (French SECAM)
NTSC 3.58 (standard NTSC)
NTSC 4.43 (modified NTSC)
1-4 SELECTION OF SIGNAL SYSTEM
As shown in Fig. 7-6, the operation panel of Model
VS-2EGN has an LED display unit (AUTO: green,
the rest: red), the there is a SYSTEM selector switch
below it. The SYSTEM switch permits manual system
selection.
Normally, reset is effected at Function-ON, and the
system selects the AUTO mode, which is detected by a
microcomputer and displayed. Accordingly, the SYS-
TEM switch is not used.
1-4-1 SYSTEM DISPLAY IN AUTO MODE
(Recording Electronic-to-Electronic (EE) Mode)
The SECAM L signal from the line input is recorded
as a SECAM B/G signal on the tape (system employing
count down of the SECAM colour signal similar to the
PAL system operation),
NTSC 4.43 signal is recorded on the tape as an NTSC
3.58 signal.
Playback signals vary from each other, and a 3-system or
a S-system television is required. The television should
be set so that the system display at the front of VS-2
EGN becomes the same mode as the displayed signal.
For details, refer to I]. Operating Procedure.
o
Cat 8/6
Ostcam 6/6
Ontsc 4.43
CISECAM L
Onrsc 3.58
SYSTEM
Fig. 7-6 System Display Unit
INPUT
LED VIDEO] PAL SECAM B/G | NTSC 4.43 | SECAML | NTSC 3.58
AUTO e e e e e
PAL B/G °
SECAM B/G e °
NTSC 4.43 e
SECAML - = o NOTE 1 -
NTSC 3.58 e
NOTES:
1.
Since
the
SECAM
L
signal
is
recorded
on
the
tape
as
a
SECAM
B/G
signal,
SECAM.
B/G
indicator
lights
in
the
LED
display
unit.
2.
When
there
is no
input
video
signal,
the
AUTO
indicator
alone lights.
(Playback Mode)
TAPE
PAL SECAM B/G. NTSC SECAM L
LED
AUTO e e e e
PAL B/G
SECAM B/G e
NTSC 4.43 = = = =
NOTE 1
SECAM L °
NTSC 3.58 e
NOTE: 1. When it is desired that signals are reproduced in NTSC 4.43, use the manual operation procedure.
14
‘Service Manual VS-2EGN