EasyManua.ls Logo

AKG HT 40 FLEXX - Backing Vocals; 5 Cleaning; Surfaces; Internal Windscreen (HT 40 PRO and HT 40 FLEXX)

AKG HT 40 FLEXX
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5 Cleaning
HT 40 PRO/FLEXX
23
1. Never let more than two persons share a microphone.
2. Ask your backing vocalists never to sing more than 35
degrees off the microphone axis.
The microphone is very insensitive to off-axis sounds. If
the two vocalists were to sing into the microphone from
a wider angle than 35 degrees, you may end up bring-
ing up the fader of the microphone channel far enough
to create a feedback problem.
Use a soft cloth moistened with water to clean the surfaces of the HT 40 PRO and
HT 40 FLEXX transmitters.
1. Unscrew the wire-mesh cap of the handheld transmitter CCW and remove the wire-
mesh cap from the transmitter.
2. Remove the windscreen (foam sheet) from the wire-mesh cap.
3. Wash the windscreen in mild soap suds.
4. As soon as the windscreen has dried, replace it in the wire-mesh cap and screw the wire-
mesh cap back onto the transmitter CW.
4.5 Backing Vocals
Fig. 7: Two vocalists max., 35
degrees max.
5.1 Surfaces
5.2 Internal Windscreen
(HT 40 PRO and
HT 40 FLEXX)
4 Microphone Technique
>
35°
HT 40_2007_Hex:Layout 1 01/14/2008 17:08 Seite 23 (Schwarz/Black Auszug)

Table of Contents