AKG PERCEPTION 120 - User Manual

Questions and Answers

J
Jennifer RandolphJul 25, 2025
What to do if my AKG Microphone has no sound?
- K
  kennedycynthiaJul 26, 2025
  If your AKG Microphone isn't producing any sound, there are several potential causes: 1. Ensure that the power to the mixer and/or amplifier is switched on. 2. Check that the channel or master fader on the mixer, or the volume control on the amplifier, is set to the desired level and not at zero. 3. Verify that the microphone is properly connected to the mixer or amplifier. 4. Make sure the cable connectors are securely seated. 5. Inspect the cable for any damage and replace it if necessary. 6. Confirm that there is supply voltage by switching phantom power on, connecting to a power outlet or inserting batteries, and checking/replacing the cable if needed.
J
James AndradeAug 4, 2025
Why does my AKG Microphone sound distorted?
- D
  Donald RochaAug 4, 2025
  If your AKG Microphone's audio is distorted, it could be due to a couple of reasons: 1. The channel gain control on the mixer might be set too high. Try turning the gain control down counter-clockwise. 2. The microphone might be too close to the sound source. Move the microphone further away or switch the preattenuation pad in.
A
Adam CraigAug 14, 2025
What to do if my AKG PERCEPTION 120 has crackling noises or low output?
- M
  Michael DanielsAug 14, 2025
  If your AKG Microphone is experiencing crackling noises or low output, it might be due to partial short circuits caused by excessive humidity. To resolve this, place the microphone in a warm, dry room and allow it to dry completely.

Summary

Precaution and Unpacking

Precautionary Measures

Ensure equipment meets country safety regulations and has a ground lead.

Unpacking Procedure

Verify all listed items are present in packaging; contact dealer if missing.

Product Description

Introduction to Microphones

Manual instructions for setup and operation of AKG microphones.

Key Features Overview

Details on cardioid polar pattern, gold-sputtered diaphragm, and all-metal body.

Optional Accessories

List of available accessories for purchase, like pop screens and windscreens.

Interfacing and Connection

General Interfacing Requirements

The microphone requires 48-volt phantom power for its condenser transducer.

XLR Connector Pinout

Details the pin configuration for the balanced output on the 3-pin male XLR connector.

Connecting the Microphone

Guide on connecting the microphone using an XLR cable and phantom power.

Microphone Usage Guide

General Usage Hints

Tips on microphone placement, moisture prevention, pop screen use, and handling loud sources.

Cleaning and Maintenance

Cleaning the Microphone Body

Instructions for cleaning the microphone body with a soft, moistened cloth.

Troubleshooting Common Issues

Resolving No Sound or Distortion

Solutions for issues like no sound, distortion, or low output due to connection or settings.

Technical Specifications

PERCEPTION 120 Specifications

Detailed technical data for the PERCEPTION 120, including sensitivity, frequency range, and impedance.

PERCEPTION 220 Specifications

Detailed technical data for the PERCEPTION 220, including sensitivity, frequency range, and impedance.

FCC Compliance Statement

Information regarding the device's compliance with FCC rules and operation conditions.

International Compliance Information

AKG PERCEPTION 120 Specifications

General

Type	Condenser
Polar Pattern	Cardioid
Frequency Response	20 Hz - 20 kHz
Impedance	200 Ohms
Connector	XLR
Supply Voltage	48 V Phantom Power
Max SPL	135 dB
Preattenuation Pad	-10 dB
Bass Cut Filter	80 Hz
Recommended Load Impedance	1 kOhm