8
No sound.
Distortion.
1. Power to mixer and/or amplifier is off.
2. Channel or master fader on mixer, or volume
control on amplifier is at zero.
3. Microphone is not connected to mixer or ampli-
fier.
4. Cable connectors are seated loosely.
5. Cable is defective.
6. No supply voltage.
1. Channel gain control on mixer set too high.
2. Microphone too close to sound source.
1. Switch power to mixer or amplifier on.
2. Set channel or master fader on mixer or volume
control on amplifier to desired level.
3. Connect microphone to mixer or amplifier.
4. Check cable connectors for secure seat.
5.
Check cable and replace if damaged.
6. Switch phantom power on.
Phantom power supply: connect to power outlet
or insert battery
(batteries).
Check cable and replace if necessary.
1. Turn gain control down CCW.
2. Move microphone further away from sound
source.
Switch preattenuation pad in.
Problem Possible Cause Remedy
6 Troubleshooting
AKG PERCEPTION 120/220
To Next Page
Loading...
