16
g. Open top cover.
h. Mount Rotary Blade Assembly.
i. Put the Top Cover back on.
j. Switch Power on and check for abnormal sound.
3) Settling Paper Jams – Paper Jamming with Paper Feeding Tray
a. Turn off power.
b. Take out paper stack on the tray.
c. Pull jammed paper out.
d. Turn on the power and press [Start] key. The paper feeding motor will start. Check for abnormal
sound.
4) Long Blade Jam
Reason – Residual paper inside – paper is too thick and rolled up.
a) When the LCD shows: Long Blade Jam, Press [Mode Changeover] and the LCD will show:
b) Press [Set Parameter] key and select [+] or [-] key to settle the problems: Press [Mode Changeover] to
EXIT.
Press [Set Parameter] to make long blade work (pressing once for each cut)
Press [+] to move paper forward
Press [-] to move paper backward
Press [Mode Changeover] to return to standby state.
c) Press [Mode Changeover] to return to the standby state.
d) Restart the machine
5) Black Mark ■ Not Detected
a. When the LCD Shows: “Black Mark ■ not detected”, Press [Mode Changeover], the LCD will show:
Possible Reason #1: In the mar
k ■ detection mode, the mark
■ is not printed or does not conform to the set requirement.
Possible Reason #2: In the mark ■ detection mode, non-white paper is used.
b. Press [Set Parameter] and select [+] or [-] to settled the problems:
Press [Mode Changeover] to EXIT.
Press [Set Parameter] to make long blade work (pressing once for each cut)
Press [+] to move paper forward
Press [-] to move paper backward
Press [Mode Changeover] to return to standby state.
c. Press [Mode Changeover] to return to the standby state.
<+>: ← <–>: →
<+>: ← <–>: →
To Next Page
Loading...
