Android Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
“ Door” “ Guest room” ,“ Hall” ,“Window”, “ Balcony” ,“Kitchen”, “ Study”
and "Bathroom”.
Zone Type: set up the alarm sensor types. You can select among four
sensor types: “Infrared”, “Drmagnet”, “Smoke”, “Gas”, “Urgency”.
Trigger Mode: set sensor trigger mode between “NC” and “NO” according
to your need.
Status: set the alarm sensor status among three options: “Enable”,
“Disable”,”24H”. Select “Enable” if you want to enable to the alarm,
however you are required to set the alarm again after an alarm is
disarmed. Select “ Disable” if you want to disable the alarm, and select
“24H” if you want alarm sensor to stay enabled for 24 hours without
needing to set up the alarm manually again after the alarm is disarmed.
14.2.3. Configure Location-based Alarm
Configure the alarm sensor in the same way you do on the web interface.
To Next Page
Loading...
Need help?
General
