7. LED Setting
7.1.Infrared LED Setting
Infrared LED is applied in a dark environment in which a resident might not be
able to see a visitor clearly via the video from the door phone. You can navigate
to Intercom > LED Setting > LED Fill Light.
Parameter Set-up:
● Mode: select ”Auto” if you want the Infrared LED light to be turned on
automatically according to the setting. select “Aways ON” to enable the
Infrared LED light to stay on permanently. select “Aways OFF” to turn off the
Infrared LED light. LED mode is set “Always OFF” by default. select
“Schedule” to turn on the infrared LED according to the time schedule.
● Min/Max Photoresistor: set the minimum and maximum photoresistor value
based on the current actual photo-resistor value detected to control the ON-
OFF of the LED light. You can set the maximum photoresistor value for the IR
LED to be turned on and the minimum value for it to be turned off. While the
default Minimum and maximum photoresistor value are from “0” minimum to
“1000” maximum respectively.
● Start Time: set the start time for the infrared LED to be turned on.
● End Time: set the end time for the infrared LED to be turned off.
To Next Page
Loading...
Need help?
General
