Akw SmartCare Plus - Temperature and Mode Configuration; Factory Default Settings; Adjustable Temperature Settings; Operational Mode Descriptions

© 2019 AKW 13-012-085-17
26
Temperature & Mode Settings
Commissioning
Mode Settings
MAX. TEMP. 43˚CMAX. TEMP. 41˚C MAX. TEMP. 47˚C
RNIB Mode
RESTRICTED Mode DELAYED Mode
User cannot set the temperature
below 38
0
C. User cannot set the flow
below medium
If shower is turned off by remote
control or smart device, the shower
cannot be restarted manually
within 2 minutes. The shower can be
restarted immediately by the remote
control or smart device that turned
it off.
WIRELESS PUMP WIRED PUMP
TEMP. 47˚C
TEMP. 43˚C
DELAYED
RESTRICTED
RNIB STD
WIRELESS PUMP WIRED PUMP
TEMP. 47˚C
TEMP. 43˚C
DELAYED
RESTRICTED
RNIB STD
WIRELESS PUMP WIRED PUMP
TEMP. 47˚C
TEMP. 43˚C
DELAYED
RESTRICTED
RNIB STD
WIRELESS PUMP WIRED PUMP
TEMP. 47˚C
TEMP. 43˚C
DELAYED
RESTRICTED
RNIB STD
WIRELESS PUMP WIRED PUMP
TEMP. 47˚C
TEMP. 43˚C
DELAYED
RESTRICTED
RNIB STD
WIRELESS PUMP WIRED PUMP
TEMP. 47˚C
TEMP. 43˚C
DELAYED
RESTRICTED
RNIB STD
WIRELESS PUMP WIRED PUMP
TEMP. 47˚C
TEMP. 43˚C
DELAYED
RESTRICTED
RNIB STD
WIRELESS PUMP WIRED PUMP
TEMP. 47˚C
TEMP. 43˚C
DELAYED
RESTRICTED
RNIB STD
WIRELESS PUMP WIRED PUMP
TEMP. 47˚C
TEMP. 43˚C
DELAYED
RESTRICTED
RNIB STD
When started, the shower setting
will be at a temperature of 38
0
C.
The shower will start at the flow
setting last used when the shower
was turned off.
Refer to Pump Installation instructions
for further detail.
STD Mode
The shower will start at the
temperature and flow settings last
used when the shower was turned off.
Factory Settings Pump Setting
TEMP. 41˚C
TEMP. 41˚C
TEMP. 41˚C TEMP. 41˚C TEMP. 41˚C TEMP. 41˚C
TEMP. 41˚C TEMP. 41˚C
TEMP. 41˚C
Factory Settings
The shower is set in its factory setting when packaged.
This is set to 43˚C.
This is not Care approved at this temperature.
Temperature Settings
To comply with BEAB Care standard and to be Care approved, then the maximum temperature DIP
switch setting must be changed to 41
0
C.
The maximum water temperature can be set to either 41
0
C, (43
0
C Factory set) or 47
0
C by changing the
DIP switch located on the control PCB inside the front cover.